How Perfect Is The Technology To Stabilize The Toilet Lid

The general toilet lid and seat ring are hinged to the toilet body through a hinge. After people use the toilet lid or toilet ring, if they do not put it down by hand, the toilet lid or toilet ring will collide with the toilet body. It generates a lot of noise and can cause damage to the toilet ring or toilet cover. For this reason, a toilet cover with a damping mechanism is designed. This damping mechanism is assembled using a fixed connection method, which is difficult to assemble. At the same time, the fixed structure of the toilet cover is single, which is difficult when disassembling the toilet cover, especially in the later maintenance of the toilet cover, which is very troublesome. Therefore, the toilet cover has the function of quick disassembly of the toilet cover. The plate fixing device has a considerable market prospect.

1. The new type of toilet seat fixing structure, including support, pads, downfaller, push rod, fixture, spring, push block, fixing pin; the fixed sleeve is fixed in the middle of the inner cavity of the stand, inside the downfaller The end fixing sleeve is placed in the inner cavity of the support. The upper end of the fixing pin passes through the side hole on the support and is sleeved in the fixing hole of the down-converter. The lower end of the fixing pin is fixed on the foot so that the down-converter does not rotate. , The outer end of the push rod extends a card outward, the card gap is inserted into the inner end hole of the downcomer, and the card is inserted into the card slot that penetrates the upper end of the fixing pin in the downhole fixing hole, the inner end of the pusher There is an oblique slider, and the oblique slider moves into the inner cavity of the fixing member in the longitudinal movement, and the pushing block moves in the transverse direction through the through hole in the middle of the support, and then penetrates into the fixing member, and the slanting slide groove on the pushing block is vertically inserted The push rod inserted into the fixed part slides slantly to the slider, the push block is fixed in the fixed part, and the spring is arranged between the push block and the fixed part.

2. A guide bar is provided on the top of the push rod, and a guide groove is provided in the inner cavity of the fixing member. The guide bar on the top of the push rod is slidably connected to the guide groove in the inner cavity of the fixing member.

3. There are two sets of reverse descenders, push rods, pads, and fixing pins; two sets of push rods and reverse descenders are respectively set on the two sides of the fixed piece.